Seat Hoops. .120 Wall- $35 shipped

[SONICJK]

And a Bump,
still cranking these puppies out

If you need one let me know

 

[sanu29]

Yep got mine yesterday super awesome cant wait to weld it up.

 

[Drey6]

Looking for a rearhoop option for my brokeback frame on the CM. Not sure how I'd make the weld job clean with all that stamped steel on this frame.

 

[SONICJK]

Yep got mine yesterday super awesome cant wait to weld it up.

Thanks man post up a picture when its all welded in.

 

[SONICJK]

Looking for a rearhoop option for my brokeback frame on the CM. Not sure how I'd make the weld job clean with all that stamped steel on this frame.

The only good way to do it on the CM is to cut that whole rear subframe off and fab up a new one unfortunately.

 

[SONICJK]

Looking at it, you could possibly cut straight along the top of the shock mount and then run a tube on top of it like this:

 

[coyote13]

Hey Sonic, you sending slugs out with these?

 

[SONICJK]

I currently am not, Once I get my lathe up and running I probably will.
With .120 wall tubing a 3/4" piece of tube works well as a slug though

 

[Drey6]

I'll play around with some options. Goofy ass frames.

 

[duggyb]

got my hoop from Sonic! looks awesome. great quality and finish and it had a kick exactly like i asked for. highly reccomend his work!

 

[SONICJK]

Thanks man I appreciate the endorsement

 

[Jay Ace]

How's the fitment on a CB750? I think it's 9" wide so just wondering if it would look odd pulled apart.

 

[SONICJK]

Not the best fit on a 750, like you said you need a 9" hoop.
Sorry amigo I really need to get a die

 

[Scratcher09]

Is 8" the correct size for a CB350?

 

[SONICJK]

yup

 

[SONICJK]

One with a kick, one with 1" tig welded in for a cb750 shipping out today.

 

[Pwbanda]

How would this fit on a '93 Suzuki GN250?

 

[SONICJK]

Dunno,
Measure the width and diameter of the rear frame rails. If its close to 8" wide and 1" tube diameter you're golden

 

[Pwbanda]

PM Sent to you my friend!

 

[SONICJK]

I'm tired of bending these by hand.
Converting to air over hydraulic should make it easier (but slower )