Seat Hoops. .120 Wall- $35 shipped

And a Bump,
still cranking these puppies out

If you need one let me know
 
Looking for a rearhoop option for my brokeback frame on the CM. Not sure how I'd make the weld job clean with all that stamped steel on this frame.
 

Attachments

  • poop shoot 009.JPG
    poop shoot 009.JPG
    156.3 KB · Views: 1,130
Drey6 said:
Looking for a rearhoop option for my brokeback frame on the CM. Not sure how I'd make the weld job clean with all that stamped steel on this frame.

The only good way to do it on the CM is to cut that whole rear subframe off and fab up a new one unfortunately.
 
Looking at it, you could possibly cut straight along the top of the shock mount and then run a tube on top of it like this:
 
I currently am not, Once I get my lathe up and running I probably will.
With .120 wall tubing a 3/4" piece of tube works well as a slug though
 
got my hoop from Sonic! looks awesome. great quality and finish and it had a kick exactly like i asked for. highly reccomend his work!
 
How's the fitment on a CB750? I think it's 9" wide so just wondering if it would look odd pulled apart.
 
Not the best fit on a 750, like you said you need a 9" hoop.
Sorry amigo I really need to get a die
 
One with a kick, one with 1" tig welded in for a cb750 shipping out today.
 
Dunno,
Measure the width and diameter of the rear frame rails. If its close to 8" wide and 1" tube diameter you're golden
 
I'm tired of bending these by hand.
Converting to air over hydraulic should make it easier (but slower :mad: )
image_14928.jpg
 
Back
Top Bottom