Willow...An Evolution

[troybilt]

$109!!!! NICE then i will def get the 350 set up for my lil bobber build!

Can't go wrong considering the price of condensers and points.

Do you know how/if it differs from the one offered on this site?

http://www.cb450ignition.com/Index350.htm

I know this one is for the CB350, but I emailed the guy who runs it, Pete, and he said to specify in the order that it's for a 360 and not a 350 and they send a different plate.

There are some differences. As he said the plates are different. They are the same diameter but the 350 plate has cut outs for valve adjusters and the 360 does not. Also the right side mounting bolt is higher on the 360. Its a bit tricky because the hold down washer falls under the contacts for the main power under the board. I'm using a hardened nylon washer on that side to avoid grounding. That may end up being the only way it can be mounted though. that could change slightly with the correct plate.
Also, I've had a hard time getting the spacing on the rotor right. I wasn't sure how close the magnets needed to be to the pickups. Just trial and error but I think I've got it. It wont take much at all for him to have these in production. infact he probably already has the plates. Hope this helps

 

[beard]

if troys tight on cash...

why dont 1 or a couple of u.. pony over $110 to him now..
he can get the pro account get the pictures up since hes a rock star now


and then when the elctronic ignitions come out.. troy can get them for free since he helped.. or he can get them at a discount... and send them off to you first serve.

my logic is mind bogggling i know

thank me later

 

[ffjmoore]

Well its been some time now and still no pictures! Whats up?