Recent content by Borisb

I do not want wire wheels but the FZR 400 wheels are a good idea. thanks

Does anyone know what wheels will fit onto an RD 350 LC? I would like to go with a little wider rim and have a rear disc and dual front discs, but am finding it hard to get a suitable swap. I have seen some that have done it but not many. Any suggestions?

That makes sense when put that way, thanks.

The motor is a Honda NS 400 R and the frame is a Honda RVF 400. I do realize the engine needs to be as far back as I can get it but dropping it down to where the rear axle, swing arm pivot line is at the top of the counter sprocket would put the motor way below the frame. A friend has a new...

I am starting an engine swap on my bike and have a question with regards to engine location. If a line is drawn from the rear axle center through the swing arm pivot should the center of the front sprocket be in line with these other two points or should it be slightly higher or lower? I do...

I have an old Nitron shock from the 90's and they say it is not re-buildable. Is there anything I can do with this to give it life again?