Recent content by Butts

I may be purchasing a 1980 CB750C frame. I'm hoping a SOHC engine will fit the DOHC frame. Is this possible without much headache?

Complete engine with carbs. I've had this engine sitting around for a while. I was going to build a quad for it but never happened. It has 8000k on it and ran like new when pulled from my wrecked bike. $350 obo. jasonbutterfield@sympatico.ca

Selling my project due to not having time to work on it. The frame has been stripped of all unnecesary brackets and the rear loop has been welded in. All welds on the frame have been MPI'd. All the original parts are there to finish the bike including the sought after tank. I didn't get an...

Duct tape will work. Its what we used at work to protect serial numbers on parts before sand blasting.

Can a normal 12 volt battery charger be used or do you have to modify the DeWalt charger?

The pipes dont have to be in perfect condition. A few dents and dings are ok as long as they aren't rusted through. Thanks, Jay

I'm in need of a set of CB 450 pistons for my 500T. I'm interested in nos or anything new that would be the stock bore size and reasonable compression. I would accept a little oversize as long as they aren't used. Thanks, Jay

How much for the front drum wheel? Where are you located?

Check out fiberglassforums.com Lots of great info on there.

I've decided to go another direction with a project due to ongoing back problems. I have a 1975 Honda CB500T and would like to get hold of a Yamaha SR500. My honda's frame has already been worked over with a rear hoop welded in. I am looking for a project bike of roughly same value. Even if...