Recent content by Gumper

Sorry for my absence guys......been busy (hiding from you Aussies whilst the Rugby World Cup Was on) Back on this now. So far as my brake set up goes, I'm using a Brembo 2 pot from a CB500 and 276mm disc from a CB900 as it bolts straight on to the hub. I shall be making up a caliper bracket...

I've sent ISR my requirements.......I'll see what their price is. Although they have a PDF price list on their site and by my reckoning it looks competitive. Also I managed to land a Brembo Oro series disc, new from the outlet of a well known UK company.....half price. It's from a ZX6R, 320mm...

I don't suppose you weighed these before fitting did you?

I'm trying to source a new lightweight front disc for my project. Looking for something about 290-320mm, alloy centre and 5 hole fitting in a relatively tight circumference. Vented preferred but not wavey. My offset is about 26mm but I'll need to make an adapter so something fairly flat is...

Works well with a tail wind.... ;D I'm in the process of sorting my front brake disc and caliper options. Also managed to machine the front wheel spindle down by 90g (3 1/2oz) Talking of weight........I realised that I'd taken off one of the shocks and had not included it in the weigh in. It...

If you're building a cafe racer then seat hump is the way to go, clip on's and rear sets too. Personally I prefer the Brat. PS. welcome.

Roughed up some spacer today at work......had lots of help and guidance. zzr250 cb250rs spacers by Groovii D, on Flickr cb250rs to zzr250 wheel spacers by Groovii D, on Flickr

Looks correct to me, looks like part 9 keys into part 1, but I'm no expert and have not done this conversion and nor do I own either bike. Many Hondas of this era had many common parts, should be cheap enough to take a punt on should you not get any further responses.

Just offered everything up and the gods of luck are on my side. The offset is pretty much spot on, just need to find something in the Honda parts bin that's a bigger diameter. Anyone......bol d'or perhaps?

I guess I'm thinking very late 70's.

I'm currently in the process of fitting ZZR250 37mm forks, yokes and caliper to my CB250RS street tracker project. I'm keeping the original wheel which has a 250mm disc, the donor bike has a 276-280mm. Can anyone with a 70's-80's Honda with disc/s with the standard 5 hole mounting with a...

I wanted to see what the bike weighs in it's original form, so with the aftermarket tat removed I pushed her on to the scales. Front 57.3kg Rear 71.2kg Total 128.5kg (in old money that's Front 126.3lbs Rear 157.0lb Total 283.3lb) Not bad wet weight (oil & brake fluid) no fuel. Which...

First off is to sort out the front end. The stanchions are badly pitted. Having priced up re-chroming or new stanchions I've decided to bite the bullet and do a front end swap to something better, lighter with better brakes. But something that will go on relatively easy and allow me to use...