Recent content by kbbecker

  1. K

    1973 RD350

    Looked at, went thru the carbs again. Nothing I could see. Same result. Do you know anybody that could look at it? I'm thinking I may have a timing issue....
  2. K

    1973 RD350

    Thanks for the reply. Supposedly they have been rebuilt and they looked fine when I changed the pilots, mains and needles. I'll go back thru the carbs one more time. The thing that concerns me is that both plugs look the same, both carbs screwed up.? Possible. I've also noticed weeping...
  3. K

    1973 RD350

    Thanks, that helps a lot. One comment, if the floats are not right I should see gas coming out of the overflows which I do not. The eingine was recently rebuilt by HVC so I don't think I have a crank seal issue or a reed valve issue. Maybe wishful thinking. I have not done a leak down test...
  4. K

    1973 RD350

    Thanks for the reply. I got it with a 170 main, 27.5 pilots and 3 on the needle without the DG expansion chambers and then moved to 160, 25, needle at 3 with the chambers. No difference. the plugs are oily which is disconcerting. I'm not sure about the igintion timing, still trying to figure...
  5. K

    1973 RD350

    Thanks, it had a 170 in it when i got it. No help. If I can get it off the pilot, on to the needle and then the main I might have some success.
  6. K

    1973 RD350

    I have a 1973 RD350 with DG expansion chambers, Y boot intake, boost tube, VAPE ignition and Mikuni VM28 carbs. I got it with a 170 main jets, 27.5 pilots and the needle on 3. I now have it with a 160 mains, 25 pilots and the needle on 3. It bogs down and stalls on takeoff (same thing it did...
Back
Top Bottom