Recent content by Luke Manion

and yes, I turned the front wheel around right after this shot. LOL

As promised... Rolling chassis photos. I still have to weld on the outer swing arm plates. I wanted to set it up as a roller to fine tune the shock placement before committing to the location of the outer plates. As it sets, I was 0.75 of a degree off on my fork calculations. I can easily...

YIKES...poor word choice on my part...or a Freudian slip. LOL

I've been stuck, waiting for the wheels and such. I want to double-triple check all of my suspension geometry with it sitting on rubber. I couldn't see mounting up the rubber, then later pulling it all apart again to ship out for powder. I wanted to save a step. Work schedule has been busy...

Thanks so much!!

Transparent Copper...its a two part powder. Chrome powder first, then the tranny copper.

Very happy with these wheels... It's an odd color to photograph. In the sun they take on so much metallic flavor, they turn orange. In the shade, they appear more copper. Super sexy bitch-o neat-o.

Finally got the wheels back from powdercoating... Transparent copper really pops. ;)

http://www.ebay.com/itm/Honda-CB-/321523841029?forcerrptr=true&hash=item4adc507805&item=321523841029 I just listed my last Café build, a '72 CB350. Great entry level café, low reserve.

Yes, john...a piece of cake! LOL I did manage to get one outer-swingarm plate made yesterday, despite a killer headache for two days. Grrrr. The right side is nearly cut out and drilled, still needs final shaping. I also noticed that the right side of the swing arm around the pivot point is too...

THANKS!! You made me make a mad dash out to the garage to grab the petcock. LOL It barely clears. LOL the move backwards helped that issue slightly. I hadn't even picked up the petcock to check it. The crossover tube is very close to the rockerbox bolt, just like the left side.

Well, the tank is on... Wheeeew. Way deeper of a project than what I expected. The modern GSRX forks were WAY easier to bolt on!!! One would think that the same brand of tank, only a few years earlier, would be a breeze to adapt. NOPE. Different animals. How to do it: Narrow your CB frame at...

I'm giving it one more shot in the garage today, to get the tank down into the frame where I need it. You guys have reinforced my persistence to make it work. The tank makes the bike!!! I've channeled the frame near the wish bone, and it needs another 1/8" per side, which is a pain in the ass...

Nice work....love the metal!