Recent content by Prutsert

Re: CB400F first cafe racer | from Holland If you like, I could mill them down for you (I live in Arnhem). Can't see it in the picture, but it may be possible to mill the whole top surface flat, and then sand it (if its thick enough).

Re: Ichiban Moto : Yamaha 500 cafe racer build Lol, would not be surprised if he'd build a gas peddle.

It's a problem on more honda models. The problem mostly occurs if the pump runs dry (a.i. gets no fuel). The plunger inside of the pump will start to vibrate? and the contacts will heat up and eventually burn away. The solution is to solder a diode parallel to the coil of the pump, this will...

Re: Ichiban Moto : Yamaha 500 cafe racer build And a nice cruise control at the same time...

I think you'll have to mill it out of square bar :( http://www.aluminiumopmaat.nl/aluminium-staf/vierkante-aluminium-staf.html

Looks great!

Beamer?

Nice build, even like the "patina" the rust gives it!

I think the coil would "discharge over the spark plug with the lowest resistance (or the smallest gap), so the engine would run on 2 cylinders....