Recent content by Ride

Check any materials on an inconspicuous area. Any clear coat that seems questionable you might be able to spray at a little more distance so that it goes on a bit more dry/flashed and thinner coats as opposed to the solvents sitting too heavily on the paint.

Lmao that’s brilliant! Is it true paint doesn’t need to be high temp on an engine? I thought I’d read that around the internets.

On a painted motor does sanding and polishing the fin edges effect adhesion of paint on the flat surfaces? I admit that while I did a good job degreasing I skimped a bit when it came to keying/scuff sanding every surface of the motor. Certainly between the fins was neglected. I used a high...

Interesting chart... is it meant to show degrees of anodic vs cathodic and imply a relative stability (borderline) between the stainless and aluminum? I’m assuming that’s how it ought to read.

Ok great thank you

No further progress just not enough hours in the day lately!

I’m building a custom battery/under seat tray. I picked up polished stainless steel for the tray/fender and hardware of aluminum angle stock (angle iron) and rivets. Then it hit me, dissimilar metals may cause aluminum corrosion. The bike is stored outside under a cover. Should I expect the...

I’ve had Air and water cooled. This is currently my only VW: original paint and less than 10k miles.

I’ll be in touch soon. I have to mock up the bike for the picture. I’ll then post up results for those following this thread. Thanks man!

That’s awesome of you! What resolution? I can use my GoPro. White sheet background?

Sounds interesting! I have no experience with paint programs, any suggestions?

I’m building a bandit with custom seat cowl and nose. I find it hard imagining the outcome when the parts are all mismatched colors. What would be a cheap easy way to try colors? And by colors I mean a silver or white just to get a rough idea? Vinyl wrap? The compound curve tank will be...