Search results

Which items are in there? Battery. Reg/rec? Starter Solenoid?

Would you happen to have any other shots of your electronics tray? How did you manage to squeeze everything in there??

It is a satin black for the most part. The rims are 18"

Hey Guys. Been a while. Wedding plans have gotten in the way but now I am back at it. I have got a fair bit done in the last couple of weeks. The frame has been sanded down, primed and painted. As well as the triple tree. I installed new steering bearings onto the triple tree. It has been...

Looks good buddy. Liking the new seat

Trek I did some measuring before I ordered my tires and it should fit. I have a spare fender and brace from a 550 which I may modify to use if I have to.

Phoenix Cokere e70p

Tires Mounted. Ready to roll. Soooo pretty!!

Oathamm The rims are gloss and the hubs are satin. Wanted both satin but didn't have a choice in the rims.

Hey Guys. A little update. Got the bearings pressed and fit. New rims showed up from mikes. Relaced front and back wheels. I sent them off to the shop to be trued and have my new tires mounted. Further pics to follow.

Still enjoying your videos dude. Glad to see progress. Bit by bit!

Thanks much Trek. Ill press it for sure.

Thanks PJ I will definitely get on that thing with a drift tomorrow. Can I support it with a vice or could that possibly damage it? When I manage to get the thing out, is it just pressed into the new bearing? Or should it be greased first?

http://www.cmsnl.com/honda-cb360t-k0-1975-usa_model440/collar-distance_42625286000/ This is the little guy I am looking for. It is pressed into the old bearing so hard that I can't get it out. I will try again tomorrow. The few spots online that I have been searching for a new one all appear...

Trek Ya perhaps I will install the new bearings. I just hope that I can press them in there far enough to squeeze the centre collar/spacer. I was just going over the schematic for the rear wheel and it does highlight the small extra "distance collar" as part of that bearing. I couldn't get that...

To reply to Tim The other side of the bearing is flat/flush like every other bearing I have seen. Only the one side has the extra spacer/reducer.

Thanks for all the replies everyone. I have attached a few more pictures of the bearings and the rear hub. Sorry that I didn't specify in my original post that indeed it is from the rear hub. Bad set up in the photo with the cup in the background. The spacer/bearing extension is part of the...

Hello All Finally getting back into the groove after a long and busy Christmas holiday. I have gotten both wheels stripped down to the hubs and I got the old wheel bearings out yesterday. I came across a problem with the new bearings I have ordered from All Balls. On the old bearing there is a...

Saturdays I definitely did a massive amount of research on the forum before cutting. Asked around a bit and decided to go for it. I wanted it to be in line with my rear wheel axle once the hoop was put on. It is slightly behind it but I wanted it to be a 1 seater. I will keep you advised on the...

Update Carbs are done. Painted and ready to go on the bike. Forks are done. Painted and I have put fresh fork dust covers on. Brake hub cap painted and new grooved brake shoes installed. I got the spokes off the rear rim yesterday and I will do the front rim tomorrow. After that it will be...