Search results

Hey all, just finished installing new bearings into a new repro rear hub for my CL100. They were a bastard to get in, and I'm worried because they're pretty tight. Like, you can't spin the inner race with a finger without exerting some force. However, when you stick a finger into a race on...

Backstory: I've got a 19" Pro Wheel spoked rim that I got for free. Came off of someone's mid 2000's Yamaha TTR125L. Never really got around to looking at it too hard because it had a broken spoke, sat on the "I'll deal with this someday" pile. I took the tire and tube off today, and it's one...

Do you really need a perfect mirror finish in your chambers or is something that's smooth to the touch good enough? After getting my head soda blasted it was still a bit icky and pitted. Since this is a 100cc head going on a 125cc jug, I realize that the comp ratio is going to be a bit high...

You guys are the best at answering these sorts of questions, so I'm back again! ;D I need to put together a thread about this build I'm working on (eventually) but I have a quick question about one of my case bearings. 6202Z bearings are NLA through Honda and hard to find otherwise. As luck...

Just got my '71 CL100 frame back from the sandblaster. Looking at the welds, some of them definitely have some contamination, but I was hoping the more welding savvy folks could dish out some advice on how to best handle some of these. Cosmetics vs functionality I'm also a bit hazy on. Would it...

Hey everybody. I know this is a long shot but anyone recognize this caliper? Casting is marked "SD" - no other identifying markings. It's in need of a rebuild and maybe a powdercoating to make it all pretty again, but I just don't know what make, model, or year it is! Kinda makes sourcing...

This is sort of a continuation of my tomfoolery with a CL100 engine. I have a 125cc jug for it now, but the case needs to be bored out by the tiniest margin. I need to remove roughly .04 inch around the diameter, probably more like .05 to get a reasonable non-interference fit. I have 2 cases...

Hey all! First post here, did some searching around and couldn't find much, so I figured I'd run it past everyone here. Are the "mystery meat" chinese jugs on ebay worth the money, or am I better served hunting around for a genuine Honda 125cc jug and piston. Not looking for max power, just...