1972 (not 1792) cl350 cylinder head o-rings?

there are no orings used on the studs at the base gasket
it is ok to use little gasket dressing on the base gasket just never use any kind of silicone anywhere in any engine
i use a fine, very thin layer of loctite 518 and recommend it highly
the 2 rear OUTER studs get the funny cyliderical orings,but up at the head gasket
the MOST important thing is using an accurate inch-lbs tork wrench on the head nuts and retorking after the first and second full heat cycle
have you got the little rubber dealies in place correctly for the center cam chain sprocket/roller axle pin ?
 
HerrDeacon said:
Are you talking about the o-rings under the cylinders? If so, #6 here: http://www.cmsnl.com/honda-cl350-scrambler-350-k4-1972-usa_model549/partslist/E05.html#results

I'll check again but I'm pretty sure those are all in place. The gasket helps keep them flat.

Also i meant the o-rings around the bottom of the cylinders. The ones pointed out in the link above
 
For anyone following this thread, I got a little impatient and put all the cases back on without gaskets or camshaft or anything like that and tightened to spec. The o-rings squashed down just fine. I was just being paranoid about the size of the gap
 
Back
Top Bottom