HerrDeacon
Over 1,000 Posts
Well yesterday evening I took my KZ650 project for it's maiden voyage. I hooked up with a buddy of mine and we took a run out to Cape Spear (the most easterly point in North America). I wanted my first ride on it to be on a nice quiet stretch so that I could get used to the bike and so I could safely test it out to see if there were any problems. There was very little traffic so it was great, nice and relaxing. The bike worked pretty good. The clutch cable needs to be adjusted a bit, and I found the rear wheel had a slight wobble to it. I have since taken the swing arm off and the bearings are shot, so I'm in the process of replacing them now. Only problem is that I have to go away this coming week so it's going to be a while before I can get back on it, can't wait.
Here is a before and after shot of the bike (before is on the right
):
And here are a couple of pics of our bikes out at Cape Spear (camera is crap so the pictures are not the best):
I have to take a few close up pics of the bike once I get the swing arm back on.
Here is a before and after shot of the bike (before is on the right
And here are a couple of pics of our bikes out at Cape Spear (camera is crap so the pictures are not the best):
I have to take a few close up pics of the bike once I get the swing arm back on.