Remove "seat rail" — Compromise suspension?

edelweiss

Coast to Coast
Please see picture below. If the "seat rail" (red arrows point to it) was removed would this effect the stability of where the shock is bolted at the top? In other words, does the "seat rail" serve any purpose in bracing the shock? Seems like it wouldn't?

Thanks!
 

Attachments

  • photo-3.JPG
    photo-3.JPG
    139.4 KB · Views: 293
Back where the second bolt attaches, is the left and right sections of the frame joined in any other way? If not, leave the rail. That's why people add rear hoops to their builds.
 
That looks to me like an optional bolt-on accessory, not a structural component. It is a grab rail to assist in getting the bike up on the centerstand.

When asking questions, it would be nice to know what bike you are asking about.
 
AlphaDogChoppers said:
That looks to me like an optional bolt-on accessory, not a structural component. It is a grab rail to assist in getting the bike up on the centerstand.

When asking questions, it would be nice to know what bike you are asking about.

Sorry, it's a 72 CB500/4. The second bolt in the rear near the turn signal holds in the rear fender. Basically, I want to lose the back fender and grab rail, but need to know if the rear fender is acting as a brace.
 
It's not structural.
There will be a rail running from side to side under the seat that is the brace
02-20-12-projectbike1.jpg
 
SONIC. said:
It's not structural.
There will be a rail running from side to side under the seat that is the brace
02-20-12-projectbike1.jpg

Thanks Sonic. So to confirm, it's ok to remove the rear fender and grab rail and ride without it. Don't worry, I have more aesthetic plans for the rear later...
 
Yeah no problems there.
Except the lack of rear fender and tail light haha.
But safety wise, you're fine.
 
Back
Top Bottom