Recent content by Black_Z28

Sounds good, thanks for your help guys. Another question regarding the clutch. In my manual it shows 2 friction discs and two plates...also in the online parts guides it shows the same and just one spring. But, I see an awful lot of companies selling kits with 8 friction discs and four...

Where would I get the 350 springs...shouldn't I replace the discs as well? If so, any recommendations on that as well? I'll check out the honda manual and see what needs to be done. Are there any tips or tricks when replacing the clutch discs? Thanks guys. I was reading that using normal...

Oh yeah, that clutch is slipping big time. I only have a few weeks left to drive the thing this year, so no biggie. It's been sitting for like 18 years, so there may have been some junk on the clutch disks. I figured I'd drive it and see if anything changes, or I could just drive it like a...

Here's a video of it up and running. Thanks again guys. https://www.youtube.com/watch?v=QiXT_grqG1M

My neighbors are pretty used to my shenanigans. I used to own a blown Pontiac Formula with basically open headers, now I have a C5 with a loud exhaust, messing around with my boat on the water hookup in the spring and fall, music, the list goes on. But I brew beer and I keep them happy with...

Well fellas...I'll be happy to announce the bike is back on the road. I got the diaphragms the other day, threw them on yesterday, and went for a quick ride. All seemed to be running very well. Made a few adjustments, and it ripping around again. I will add, my dad bought this bike for my...

Went ahead ordered a pair through this company. Should be here in a few days. I'll throw it all back together and put a video up next week. Thanks for your help guys.

Sounds good guys. I was planning to order a pair of diaphragms....they're 40 years old...so they served their time. So, I was looking at how to remove and re-install. Not quite sure how to do that. Anyone have info on the removal and install? Thanks for all your help.

Well, I took the carbs off the bike.....and behold my infinite wisdom, I forgot to install gaskets for the manifolds to engine. I'm sure that didn't help at all. I also discovered a tear in the diaphragm for the carb that always seemed to run a little worse. So, I installed the new gaskets...

Oh yes, my knowledge of carbs is very intermediate at best. I'm used to hooking up a PC and tuning my car by wire. So, I'm getting used to this whole carb thing, and I'm trying to learn as much as I can. I'm planning on a compression test, I should call the local parts so to see if I can...

Hello, I've been working on this bike a little while now, here and there when I have time. It hasn't been driven in over 16 years, and I'm now at the point of driving it around. Anyways, a little about what I've replace. The mufflers were shot, so I replaced them with a set of 16" slash cut...

I just ordered these as well. They come with both a metal washer and rubber seal. Do you happen to know the orientation of the two? I assume rubber seal, then washer then the snap ring on top? Also, this is my first shock rebuild. Do you simply just add the recommended amount of oil before the...