Recent content by bustedknuckleLRSU121INF

How did those forks work out?I'm looking to do something similar.

i recently picked up a 1974 cb450.This is my 4th build and I want to go for a real custom look as well as increase the performance of the bike.Is there a late model bike with dual disk brakes where the the whole triple tree and forks can be mated to a 1974 cb450 frame.If so do you know what neck...

Re: HONDA 350 twin hardtail frame You have a picture of the springer front end that goes with it?

I'm working on another cb350 build and I decided to use All Balls brand sealed wheel bearings.The issue that I am having is that with both bearings seated completely and with the spacer in the hub in place I am still having a gap of about 1/2-1/4 inch on the sprocket side between the bearing and...

Didn't even think about that the stops on the triple tree.It seems like most of the bikes I've built from have all been laid down at some point and those stops will be gone on one or both sides.The bottom half of the triple tree is cast steel(the top is aluminum).If its missing don't worry about...

I don't have the specs in front of me but the main thing is that both sides have equal compression.if it has been sitting awhile clean the carbs and check the seals.No reason to buy a complete rebuild kit unless they are missing parts. BUY A REPAIR MANUAL.I can't stress that enough. Clymer makes...

I had the same problem on a build.I made a removable kick start and extended it so that it would clear my rear sets.Have you tried moving your rear sets are are you attempting to use the passenger peg mount location?

Ebay has a ton of choices for cheap when it comes to turn signals.same goes for the taillight.I would stay stock with the headlight.Keep it simple. Suspension. I run stock rear springs on my 550 and 350.My guess is your front fork seals are bad.cheap fix 20 bucks total. I would have to see the...