Recent content by CBGhia

seconding Junior's 400. The aluminum fairing is the tits!

I used a lot of degreaser and a wire wheel to scuff everything. Then self etching primer on everything and then paint.

I have some very clean 650 carbs. They need new needle valves and an Air cutoff diaphram, but they carb parts are all there including the platic choke mechanism. I also have a set of nasty carbs for the same bike. These carbs need new floats as well as a full rebuild, but again they are all...

start here: http://forums.sohc4.net/index.php?topic=5752.0 Any questions you have about a CB550 can be answered there.

You have spark, but is it coming at the right time? You should check your points and timing for the 1-4 cylinders (they share points and coil). Well... I am assuming this is a CB something or other, if not then ignore what I just wrote.

My interior is not finished. i could take some pics, but they won't look good. LOL

Here is my Ghia.

The guy on Saturday was a moron and was just trying to get a new account (he has to open a certain amount). You did not need a new checking account if they are only charging your card. You needed to close the card immediately and order a new one. Hell, he could have given you a temp card on...

it has nothing to do with the start button on the bars. I am sure the hand controls are fine. If you follow the pos wire from the battery, you will see that it leads directly to the solenoid. The other post on the solenoid leads directly to the starter. Internally the solenoid has fused...

Ok, I see that. How are you doing the seat? I bought 2" high density foam for mine and shaped it out (not finished). If you used foam that think it would cover the hole anyway and you could just have a small lip at the front to add rigidity kindof like this.

Dude, I love the bike. I just wired my 550 and it was scary, but luckily it wasn't crazy like yours. I just wanted to say that in my opinion you should NOT put that hump on the front of the seat. I think the shape of your tank is perfect and that hump will change the way it looks. Just my...

I had a hole in the bottom of my exhaust. I bought muffler weld from the local autozone. It is a goop that comes in a can that you spear over the hole. I haven't run it yet, but it dried really hard and looks like it will work.

Unfortunately, i do not own a set of r6 rear sets, i do however have a set of gsxr rear sets, but they are not perfect. One of the pegs has some rash. i can send you some pics of those, or we can talk cash.

So what are you wanting to get for the carbs?