Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature currently requires accessing the site using the built-in Safari browser.
We noticed you are blocking ads. DO THE TON only works with community supporters. Most are active members of the site with small businesses. Please consider disabling your ad blocking tool and checking out the businesses that help keep our site up and free.
Thank you both... I've seen fish eyes before but never like this. It looked great until I sprayed this last coat...
Sent from my iPhone using DO THE TON
Hi guys, been awhile but I'm back with another rookie mistake and appeal to your collective knowledge on how to fix it.
I've been slowly building up metallic paint on my CL360 rims to get a near-chrome finish. Things were going well, super shiny, until I went today to do final coat and bam...
This is great stuff. I'm not very experienced (halfway thru my first restoration) but I switched to the white appliance epoxy (rustoleum) after my can of white engine paint ran out and was waaaaaay too hard to replenish--the appliance paint looked just as good and laid down so great, half the...
Hi y'all. TL/DR: can I use JB weld to repair this hole in my tank?
I was stripping paint from my Honda CL360 gas tank today and have been shakin stones and vinegar inside for about a week--suddenly just discovered this pinhole in the top of the tank near the seat due to rust (inside and out I...
@iatethepeach Aha! I had only found it for more than twice that + shipping. Thanks so much, I think I can swing that ;)
Sent from my iPhone using DO THE TON
hi guys. This'll be my first time rattle canning a tank. I plan to do a design in the same color and pattern like the one in the picture (not my tank, obv).
When it comes to striping I usually see folks say lay the lightest color as base, mask with tape and spray new colors up to darkest. So...
Hi guys. Project is a 74 CL360 restore. The rear rubber tank mount is shot after the bike was sitting for 20+ yrs. i've seen a few on ebay but they seem kinda steep for something thats just rubber and isn't seen when the bike is put together.
Question: does anyone have a hack recommendation...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.