Recent content by Curtis

Not even worth the swap then.

Any updates on this?

Thanks, Not having road an XR 200, will I notice a huge difference or no?

Looking into doing this swap on my CB 125 What years of XR 200 head and barrel work Is it a direct swap What all do i need? (carb, header, anything else?) Thanks, Curtis

No pictures show up?

Wouldnt change a thing if it was my bike, looks great!

clean all of the solvents off it that you have sprayed on. Next, take a small butane or propane torch with the carb and cable off the bike, put the carb body in a vice so both of the 'mouths' are in each jaw, tighten down with enough pressure to hold it, but not break it heat the sides of the...

You should put a single fishtail pipe on that sucker

Re: Out in a field Build .... How well is the speedo cable going to clear the center of the headlight?

I completely agree, pull the clutch pack out, carefully pull each plate out, re surface the steel ones, check your fibre plates, if they look deteriorated or ripped, just buy a clutch kit, they are only about 50-75 bucks. and well worth the money for when the bike is together and running/driving.

http://www.ebay.com/itm/Honda-CB500-CB550-CB750-four-4-Cafe-racer-seat-and-tank-/120799263768?_trksid=p5197.m7&_trkparms=algo%3DLVI%26itu%3DUCI%26otn%3D5%26po%3DLVI%26ps%3D63%26clkid%3D3735158185960704002 Looks pretty neat

Re: SoCal Mut-N-Chop CB750 Sounds more like a short in the headlight itself... You dont by chance have the ground for the headlight plugged into the wrong spot on it?

Love it, do you have any more pictures

dont forget your toque eh. Any updates?

ya, about 4 hours south west of ottawa, lol. I am about 45 minutes to toronto on a good day