Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature currently requires accessing the site using the built-in Safari browser.
We noticed you are blocking ads. DO THE TON only works with community supporters. Most are active members of the site with small businesses. Please consider disabling your ad blocking tool and checking out the businesses that help keep our site up and free.
Thanks,
I've used por15 for sealing the tank in the past. Worth it.
I have decided to go weld.
I have a mig welder though.
Is that any good?
The picture below after a 5 minutes sanding.
Thanks
El__burro
hello,
i am about to complete my cb750 project.
unfortunately while i am washing the tank to seal it, I've notice a few tiny holes.
sure there are more as i sand off the paint.
my question is, how do i close them?
regards
el__burro
You are right. In other words the kill switch doesn't kill the starter motor.
Trying to do more tests on the oil pressure switch. Light doesn't come on. Oil is fine. All wiring too.
Thanks
El__burro
Actually I worked on a spare I found in the box.
Here's what I achieved.
It's a perfect fit.
Now I am working to stop the little spill of oil on the forks.
Thanks
El__burro
Cb750 oil pressure light OFF.
thanks both.
bulb is ok, i swap it around with neutral and its fine.
i have no resistence (or Biiiiiip) between wire and negative battery.
i also tried on the switch itself.
only when I touch the outside part of the switch it beeps ( i guess its normal)
i guess its...
I'm putting the wiring loom back on the bike (k2)
My hurdle is that the oil pressure light stays off when I turn the key.
No isssue with Neutral light.
90% sure it's no wiring issue.
Can it be the switch itself? How do I test it?
Any other suggestions
Thanks
El__burro
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.