Recent content by jsedacca

BTT. Need gone asap.

Still available. Need to sell asap.

still available

The CB750 project has been put on the back burner while wedding plans are sorted. I need to free up some cash and this tank needs to go. It is the alloy Manx TT tank from legendary-motorcycles.com and comes with the Monza cap. It is finished in the brushed/mill finish and is pretty much a...

PM sent Kiley

Updated the original post with 2 more pictures showing a measurement of their length, and a pic of the brackets installed on my brothers CB360. They were mocked up, and removed as he went with another setup. Need these gone asap. Thanks guys Jared

Bump. Need these gone so make some offers.

Bought these when I was doing a cb350f project, and no longer have a need for them. They were purchased from Kevin at TTR400.com and they are NLA. They are machined aluminum, and anodized black. Works on 33mm forks only. 2 piece design allows easy install on fork tubes. $100 shipped in the...

You can drill the sleeve out, but it gets close to completely removing it. Here is a better/safer solution: http://jokermachine.com/products/cafe-racer/honda-cb160-175-200/honda-cb160-swingarm-shock-bushing.html

cb750 4-1 exhaust

I was going to use the GL1000 front end for dual discs, but have decided to go with USD forks on the front. The forks are in good condition, with no leaks and function fine. The wheel comes with the discs, axle, and spacers. Only part needed is the speedo drive to complete the front end...

Just received this today from Legendary-Motorcycle for my CB750 project.

Where are you located? I have a front end coming off a 78 CB750K. Let me know

Just finished up this project, and thought I'd share. I found it up in Michigan on ebaymotors.com. It has a clean title, and when I took delivery of it, ran and drove. Being from MI, it had some rust on the frame, and wheels. The tank had a considerable amount of rust inside, but was solid...

Have you checked your plugs and get a reading off them? The jetting from DCC is close, but still not ideal. The pilot jets they provide (50s) are way too big. The throttle slide should also be a 2.5 instead of a 3.0. Finally, change the needle jet to a P4 or P5. I have the above mentioned mods...