Recent content by Kwality

Outstanding. Some excellent advice there.

score!!

You can lsit them in the for sale area on this site. Perhaps point to that listing on the Australia sub board? Or ebay? Or gumtree?

Welcome - I'll be following your build with interest!

If you stick a broomstick or similar down inside the fork, then you can usually apply enough pressure to be able to undo the hex bolt at the bottom. Also, do you have a grease gun? I've worked out very stubborn brake pistons using one. The thread on my gun is similar to the bleeder srew...

Re: 77' cb400f project getting underway. Looking good! Subscribed.

Welcome. Great bikes. Did you work out why it was seized? Sitting outside without carbs in the weather for a while will do it, but there are other potential reasons too. Good luck - (you might consider starting a build thread in that section of the site!)

back to front or upside down? Have a look to see which side the tach worm gear is.

Good stuff! Love the 400f. Subscribed!

Yes indeedy. Love the 400f and am keen to see where you go with this.

Nice work as always Swan. Love the attention to detail !

Not good, just.... odd. And I'd be sad if the thread disappeared too - it's been quite the journey so far. What's next Neevo?

google "tank electrolysis". You might find it useful (although you'll need a battery charger).

Hey Sonicjk - yes, it's from the Cb400f supplement to the Honda Shop Manual. It's funny how things goo missing over time. I've had a few of these bikes, yet none of them have had the (I'm guessing) rubber strap that wraps over the harness to the front of the coils on the left hand side. The...

The attached should help re the routing of cables and wires. cheers,