Recent content by Lunatic

Vinyl works great for that, I did my side covers and a couple of helmets that way. You just want to make sure they aren't super sticky so they don't leave a residue and aren't too hard to remove.

Yeah that does seem high for shipping. I remember it showing up via canada post in a small envelope. The whole unit is actually smaller than a typical load resistor too.

Tim, junk the resistors. I used one of these on my XS and it works perfectly and there's no heat issues. Cheaper than resistors too I think. http://cgi.ebay.ca/12V-Adj-Flash-Electronic-LED-Flasher-Relay-Bike-C-/150618727125?pt=Motorcycles_Parts_Accessories&hash=item23119362d5

Have a look at this thread on XS650.com http://www.xs650.com/forum/showthread.php?t=5390

www.xs650.com There are a couple of threads about swingarms. I believe someone mentioned Yamaha Radian works?

You might want to post up something at xs650.com, you'll get specific xs650 advice and probably quicker responses. Having said that, if your jetting is stock, have you tried playing with the mixture screws? I would double check the pamco, make sure the timing is correct, when I did mine we...

When was the last time is ran properly and what has changed? Plugs will foul with the choke on when the bike is running properly, but it sounds like the bike is running really rich. Stock carbs or have they been rejetted?

I'll be at Lakeshore and Leslie around 8:30 and then heading to the Dice for 10ish.

There are many, Tim, Loco, Gilligan, and I all have XS650's. I'm sure there are more.

Thanks for looking. I'm going to hit up a couple of the used bike places in town.

Hey Noel, did you get a chance to see if you had an extra master lying around? Even if it's from a different bike we may be able to get it to work for me. Thanks!

Cool, thanks! Weird about the 83 with mags having drums... is it a special or a standard?

This is the best pic I can get at the moment. You can't see it well, but it's the plastic elbow going into the hose with the clamp on it. XS's with mag wheels had rear disk brakes.

Hi all, I'm looking for a rear master for an XS 650. Really all I need is the little plastic elbow that goes from the master to the reservoir, mine got broken when the bike tried to eat my taillight and license plate. Thanks!

So is the Mascot open late for this? The hours listed say it will be closed at 7pm?