Recent content by pitboss

im looking for a solid cl360 tank with the petcock on the left side. please message me if you have one. thanks

i have a set of mikuni vm30's with some extra mains and pilots. i bought them a couple years ago and ran them on my 360 for a couple months and changed them again. they have been in a box in the shop since. i also have a set of dcc rearsets with the linkage set up for my 360, i used these for a...

okay maybe i over priced these a bit. carbs only. make reasonable offers!

pm sent for 360 carb sync adapters.

I am selling my vm 30 carbs along with 2 pod filters, 3 used throttle cables, a single pull throttle assembly, as well as some random jets.Tthe mains are 170,180,250. the pilots are 25,30,35,37.5,40. no clamps for the pods. 250.00 including shipping. thanks for looking

the tires are donlop 404's 110/90/18 rear and 100/90/18 front. its the stock 360 tank with the sides dished in. so far i like the fairing but it could come off at any time.

i bought this bike in october of last year. here it is the day i brought her home. and here she is as of last weekend. it has been alot of fun to buid and alot more fun to ride. thanks to crazypj for the starter block off plug sonreir for the gauge graphics and the mikuni 30's and and...

i ran into this same problem with my mikunis. i switched to a single pull throttle from motion pro and mine works like butter now.

im digging all the fab work, looking good so far!!

hey az how did this work out for you? im doing the same thing with 30's and a push pull and same 2into 1 cable from dcc, mines really hard to open and sticks pretty bad. i used half a can of tri flo inside the cable. oh my adjusters on top of the carbs were broke. im looking for a whole new set...

good start, good idea on the bead breaker to. happy building.

YES good idea!!! there is a bike shop right down the road, thanks

been a while since i made any progress but i got the fairing cut down today. some before pics. and some after

im missing the little 5/16 bearing that goes in the actuater and pushes on the clutch rod. any ideas.

my dcc rear sets are perfect for my cl360, and they didnt break the bank!