Recent content by revlow

The only reason for thinking to replace was the rubber is deteriorating Sent from my HTC One_M8 using DO THE TON mobile app

Hmm I guess it's not even shown on the diagram Hope this helps, I wish it was as easy as the pin Sent from my HTC One_M8 using DO THE TON mobile app

Doing engine work on my bike this bushing needs to be replaced. Told by Honda they don't make it anymore. Any one know where to get one. I'm pretty new to this stuff Sent from my HTC One_M8 using DO THE TON mobile app

This is on a 74 cb360 Sent from my HTC One_M8 using DO THE TON mobile app

So I think I screwed up today. Getting ready to pull the engine out and went to take the tach screw out it was damaged and I planed on replacing it. I took my drill and drilled the head off as I did with the chain cover (I didn't think it threw as the chain guard just pulled off but this is...

Hey man, can you tell me more about the filters your running on those carbs -RevLow

That explains why the one in the Manuel looked different, thanks, I'll look into this and find the part. -RevLow

Trying to get my 360 to turn over, I've got it connected to my car battery and bypassed the solenoid and it sounds like its on the edge of turning. I'm panning on removing the carbs to clean them and check them out. I know there is a plug that commonly falls out and I'm not sure if mine is...

I've never done anything like that however. Are there any special tools I'd need just to get it apart enough to replace that shaft and then put it back together. Sent from my HTC One_M8 using DO THE TON mobile app

With running normal electronics ? Sent from my HTC One_M8 using DO THE TON mobile app

I'm planning on putting this battery in https://www.batterystuff.com/powersports-batteries/YTZ7S.html so it would be nice to have kick start as an option, the cases have been split before, and winter is coming soon. I'm upgrading the charging system to the rr shown. Hoping that battery will be...

Well thank you, here I was thinking I wasn't tightening it right. If anyone has a spare they want to sell shoot me a message Sent from my HTC One_M8 using DO THE TON mobile app

I picked up a cb360 the other day the po removed the kick start leaver and was running electric start only. I'm wanting to put the leaver back on but it will not stay on, I put it on the spindle, then tighten the bolt on the leaver but it's not staying on, after one kick the leaver falls off...