Recent content by Rock_Star

does your starter have an o-ring? make sure o-ring is in good condition, also torque the bolts or screws to spec.

They look almost the same as my cb550k carbs. GLWS

Primary gear/ primary shaft? (The one that goes all the way through the case? I did remove the shaft and whatever is connecting it. I have the whole clutch basket and all the bracket behind the kickstart side off. Yeah, I'd removed the last bolt under the oil pan. Idk if it's just me, but I'm...

i do see the (1) bolt inside the oil pan. i wasnt sure if that one was connecting the two halves. i mind as well remove that bolt too. i did already removed every bolts and screws there is on the lower case. ill give it a shot. btw where would be the best point to hit it? do i need to remove the...

I'm tearing down a cb550f motor. i got tadpit cover, valve cover, the jugs, and the cylinders off, but now it seem like the lower case doesn't want to come apart. I've unloosen and removed all the screws holding the case together. I've been at this for the past two days with no budge... I'd been...

thanks

after V-stacks are installed bike began to lean out after 3/4 throttle. if i was to upgrade my main jets on my cb35f, do i also have to adjust the needle heights as well? and how many turns on IA screws? setup: 350f V-stacks "stock" 4-2 exhaust stock carbs stock jets 75:75:75:75

for hondas what gauge wires?

for the love of god, photobucket is not responding >:( i guess ill just have to open it and see what it is. mnay thanks for the replies

on a side note, by looking at my cb350f the location seems to be in the same location.

id recently acquired this non 76 cb550f. as i removed the motor and was reading through the manuals, i could not find the oil fill/dipstick cap. googled, read a few threads and opened clymer i didn't see anything that look like similar. i have a clue to what and where it could be, as inspecting...

nvm i saw this to late ;D

hi everyone. i just want to introduce myself a little bit. Ive been a long time reader and a DIY'er. Im from the bitter sweet cold Twin Cities, Minnesota. i loves tinkering with bikes and cars. -lee