Recent content by WJPez

That looks very nice :) Wayne

Hi stan0matic, I adjusted the tappets as per your instruction and gave the bike a run, all seems ok. There is a tappet noise that was not there from new but as there was no gap when I originally checked then that is not a problem. Wayne

There is a seperate thread running about this, take a look. http://www.dotheton.com/forum/index.php?topic=58483.0 Wayne

The conversion kit is now on th OORacing website. Who will be first? http://www.ooracing.com/store/index.php?act=viewProd&productId=4839 Wayne

The nuts were tight when I rechecked them. I gave the bike a short ride last night and it appeared to be ok although it may have been slightly down on power. Wayne

I decided to finally change my rear sprocket at the weekend, my only problem was trying to raise the back wheel off of the floor. After many attempts with the wife using blocks of wood I had a flash of inspiration and used the ladder and a couple of ratchet straps. Wayne

Thanks Stan, I will take any advice that gets me back on track. I did reset everything yesterday afternoon and the bike started ok, but I did not go for a ride as I wanted to get advice from the guys on here. What confused me was that for the first 15km everything was fine and then the...

I used the line next to the "T" Wayne

I left the bike overnight to get cold before adjustment. When I rechecked the gap yesterday the locki nuts were both tight. Wayne

Help! I have adjusted my valve clearance to .002". I also replaced the rear sprocket from 38 teeth to 35 teeth. I took the bike for a run and all seemed well for the first 15km. The bike then lost power like it had run out of fuel but picked up again after about 5 seconds. It did not sound right...

Thanks for the advice Tad and stan0matic. I will change the sprocket and see how I get on. Wayne

Thanks Tad. Would you recommend just replacing the standard foam over fitting a replacement filter assembly. I was not looking to replace the carb at this stage. I have re-jetted with 45/95 and fitted the derestricted chrome Skyteam exhaust. I am maxing out at 65mph as was looking to try and...

I am looking to replace my air filter with one from OORacing:- http://www.ooracing.com/store/index.php?act=viewProd&productId=3719 What modifications do I need to make so that this will fit? Can I keep the original battery in the same place? Thanks Wayne

Thank you. Wayne

Hiya Haz, Do you have an ebay link? Thanks Wayne