Search results

I have been working on this thing for a bit. Just purchased a VM36 mikuni carb from Sudco. The problem is with the custom frame I have it hits the downtube under the seat when the air filter or velocity stack are on. Anyone know of a 45 degree manifold for these? Sent from my iPhone using...

Been working on this bike for a while now, between moving cross country, remodeling a house, and life, it's close to being done. Just some small stuff to complete it. If anyone knows a good place to grab a Triumph clutch cable with Harley type lever end, let me know. You can see more updates...

Painted very well in British green. Metal covers, NOT the fiberglass Excellent condition, make an offer. Sent from my iPhone using DO THE TON

I was thinking of using AN fittings to run nice hard lines on my '74 triumph bobber. Has anyone done this or have suggestions on what type to use with steel vs. aluminum?

So I'm building a Hyper motard out of a 1969 TRW25 that i just finished the motor rebuild on. What I'm trying to figure out is what swingarms I could replace the stock swing arm with. I'd prefer a dirt bike swingarm to give me the height I need and give it a more modern look. So the stock...

Anyone have one in a vintage Triumph? I've been looking at the ones that are internal like this: http://www.britcycle.com/Products/55820.htm But found this one: http://www.btosports.com/p/MGHC Was wondering if anyone had any opinions? My forearms are getting too big riding around town... :P

Always looking for vintage triumph stuff... disk rear hubs, tanks, frames, basket case motors, etc. I have lots of extra used triumph parts as well, let me know what you are looking for and what you have, maybe we can make a deal.

Took the time to join up over the holiday, but just now finally have the time to introduce myself. My name is Chuck, I've been riding since I was 15 (a long time ago). Bought my first motorcycle before my first car at 16. The PA winter's were a little rough on that '85 VF500F Honda. Since...