Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature currently requires accessing the site using the built-in Safari browser.
We noticed you are blocking ads. DO THE TON only works with community supporters. Most are active members of the site with small businesses. Please consider disabling your ad blocking tool and checking out the businesses that help keep our site up and free.
I did not check any resistance on the 3 ohm coils.
They said,
"If you have the green coils they are 3 ohm and are not the correct impedance for the stock ignition. You need the gray 2.2 ohm coils for maximum energy to your plugs. Even if you have the 2.2 ohm coils the stock ignition is old and...
So I talked with the folks at dynoman where I bought my carbs. They asked if I've done anything to my ignition. I told them I had 3 ohm dyna coils on it. They told me I needed the 2.2 ohm coils. I bought them, installed em. Now she goes like a bat outta hell. Just thought I'd share
So after a lot of screwing around with a new 14mm m/c, scratching my head, doing research. I couldn't figure out why the lever still went all the way to the bar. Just got another Nissin master but this time 5/8" (15.88mm) it's hard as a rock now. Should be noted that if you have too small of a...
I cheaped out on a Kenda rear tire. It was so out of round it would vibrate your fillings out. Returned it for another one, and it was just as out of round. Moral of the story is don't go cheap on tires.
Checked timing. It was a touch off, now it's perfect. Still same issue. Cklamer hard to believe I can't bump my main jets way up. They go all the way to 225 on jetsrus. I've done nothing special to the engine and the 29s are recommended for my bike with either velocity stacks or pods. I'm still...
Thanks for the advice cx. I'll check that when I check my timing. Yeah sounds like a pretty good deal tuna. Where you wanna meet up. I'll bring the lube.
Not positive about the timing. It's getting plenty of fuel. I talked to a carb guy from
cycle-x here in Wisconsin. He said it could very well be an air leak. He said spray carb cleaner around the boots while the engine is running, and see if there's an Rpm change.
We'll see.
What I've got goin is...
81 cb750c
Keihin cr29s
K&N pods
Cycle-x 4-2-1 race system pipes.(very open)
Bike runs great till about three quarter throttle, then starts bogging, then at full it will just about kill itself.
Before I start doin plug drops and ordering jets and needles I'll ask this...
Hey there fellow motorbikers.
Here's what I built and ride.
81 cb750c.
Hope to gather knowledge on here as well as give some out.
Keep the rubber side down!
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.