Search results

nice transformation, i am finishing the same bike and the style is roughly the same. keep us posted. ps do not make a move without the 3T. el__burro

Thanks, I've used por15 for sealing the tank in the past. Worth it. I have decided to go weld. I have a mig welder though. Is that any good? The picture below after a 5 minutes sanding. Thanks El__burro

actually the holes are the 2 black spots. I've used por15 before but with no holes. any other suggestions? thanks el__burro

The filler option is my favourite choice. Any? Thanks El__burro

hello, i am about to complete my cb750 project. unfortunately while i am washing the tank to seal it, I've notice a few tiny holes. sure there are more as i sand off the paint. my question is, how do i close them? regards el__burro

Which oil pressure switch is suitable for my cb750 k2? They all look the same to me. are this one ok? Thanks El__burro

You are right. In other words the kill switch doesn't kill the starter motor. Trying to do more tests on the oil pressure switch. Light doesn't come on. Oil is fine. All wiring too. Thanks El__burro

i am confused, on a specific honda sohc i was told differently about this.

Ign on + push button engine starts. Ign off + push button motor turns (engine doesn't start) Is this regular? Thanks El__burro

Actually I worked on a spare I found in the box. Here's what I achieved. It's a perfect fit. Now I am working to stop the little spill of oil on the forks. Thanks El__burro

maybe it has nothing to do with this but I have both wires to the kill switch disconnected but still i am able to start the motor. thanks el__burro

is that the only to test the switch? i guess i just need to unscrew and try a new one.

Cb750 oil pressure light OFF. thanks both. bulb is ok, i swap it around with neutral and its fine. i have no resistence (or Biiiiiip) between wire and negative battery. i also tried on the switch itself. only when I touch the outside part of the switch it beeps ( i guess its normal) i guess its...

I'm putting the wiring loom back on the bike (k2) My hurdle is that the oil pressure light stays off when I turn the key. No isssue with Neutral light. 90% sure it's no wiring issue. Can it be the switch itself? How do I test it? Any other suggestions Thanks El__burro

Good morning I need to replace both battery cables for my cb750 k2 but I am not sure what to look for. Any suggestions? El__burro

i guess i was looking for the wrong part. the one i need is number 9 not 15. correct? thanks el__burro

hello, i am starting a dual disc conversion on my cb750. i have to purchase a cb500/550 but Im not sure if the one i already have is for 750 or 500/550. i am trying to google for the difference but cannot find any. any help? thanks el__burro

sorry, i forgot to say.. its done. just applied some heath and a good allen key in a vice thanks el__burro Sent from my iPad using Tapatalk

I would have loved to have done the knees indent.. Lovely job. El__burro

Good morning, I am trying to find an easier way to remove these stubborn bolts from the callipers. I tried with a lot of wd40 but I am only damaging the bolt. Any suggestions? El__burro