Search results

tis for sale , on ebay :o

Wanted ei metering rod, late type lectron and edelbrock quicksilver 2. May also be ok.

It rubbed a bit of the piston over the ring and a little bit of pick up on the side of the piston , was fixed and back together in a few hours, skimmed a little out of the head , will be ready soon for more testing

taken just before it went pop! 16.5:1 compression proved too much

tank welded and leak free! , strapped up , all lock wired and waiting to go, will be testing in july 28 , got four 7lap sessions booked

http://youtu.be/XGGDg9Skz24 it runs

alli tank coming on

adapted to hydraulic clutch , so nice and light action, build a new crank as wasn't sure original would take 10,000 rpm, now its only 96mm dia

adjusted the screen height today. test run of the engine in the morning

built the rear wheel. fitted chain and sprockets , plus a ton of other mods and bits!

i'l post some pictures of the engine mods soon, but heres where its at now fitted fairing, waiting on rear wheel and new rear springs,

made an exhaust, made a new liner to take suzuki 185 piston from wiseco , fitted a kx250 wiseco rod, modified the crank , ported and moved crank bearings too, plus lots more a can't even remember now

done a few things

no , learning as i go! i've got another build on here a gs550. finished that a while ago http://www.dotheton.com/forum/index.php?topic=25628.msg274688#msg274688

what it'll look a little like

it already had a hole to take the shaft out the right side, just removed the plug that was in it , then turned the selector mechanism around, turned some new cir-clip grooves and fitted an oil seal and turned an o ring groove in the shaft ; then plugged the left side with the bung taken from the...

its an alloy tank , i made the bearing cups myself ,and just bought normal metric bearings to fit the yamaha stem

got a front wheel and nice sticky race tyre , fitted a disc and brembo caliper , plus other bits. i'll get an updated photo soon

the forks are from a yzf r125.

a bantam racer, converted the gear change to left hand , started to make the tank almost done, need the tunnel welding in and mounting points, head has taper roller bearing cups fitted and new positions for the rear sets