Search results

Good to know, the basement is a little cold, I'll have to figure out how to heat things up. Thanks! Sent from my iPhone using DO THE TON

I didn't @rusnak_322, but that's good to know! Sent from my iPhone using DO THE TON

Thanks again guys! Sent from my iPhone using DO THE TON

Thank you both... I've seen fish eyes before but never like this. It looked great until I sprayed this last coat... Sent from my iPhone using DO THE TON

She's a beaut! Sent from my iPhone using DO THE TON

More pics: Sent from my iPhone using DO THE TON

Hi guys, been awhile but I'm back with another rookie mistake and appeal to your collective knowledge on how to fix it. I've been slowly building up metallic paint on my CL360 rims to get a near-chrome finish. Things were going well, super shiny, until I went today to do final coat and bam...

This is great stuff. I'm not very experienced (halfway thru my first restoration) but I switched to the white appliance epoxy (rustoleum) after my can of white engine paint ran out and was waaaaaay too hard to replenish--the appliance paint looked just as good and laid down so great, half the...

Thanks, guys. You convinced me to go with brazing. No equipment for that so I'll try a professional. Sent from my iPhone using DO THE TON

Hi y'all. TL/DR: can I use JB weld to repair this hole in my tank? I was stripping paint from my Honda CL360 gas tank today and have been shakin stones and vinegar inside for about a week--suddenly just discovered this pinhole in the top of the tank near the seat due to rust (inside and out I...

Thanks guys! Sent from my iPhone using DO THE TON

What a great trip. Good on ya, hope you and he have many more adventures ahead. Sent from my iPhone using DO THE TON

@iatethepeach Aha! I had only found it for more than twice that + shipping. Thanks so much, I think I can swing that ;) Sent from my iPhone using DO THE TON

hi guys. This'll be my first time rattle canning a tank. I plan to do a design in the same color and pattern like the one in the picture (not my tank, obv). When it comes to striping I usually see folks say lay the lightest color as base, mask with tape and spray new colors up to darkest. So...

Hi guys. Project is a 74 CL360 restore. The rear rubber tank mount is shot after the bike was sitting for 20+ yrs. i've seen a few on ebay but they seem kinda steep for something thats just rubber and isn't seen when the bike is put together. Question: does anyone have a hack recommendation...

thanks. Thats my plan! Sent from my iPhone using DO THE TON

@iatethepeach LOL definitely not trolling. Learning my way around a rebuild for first time, mostly from this site+youtube/forums. well I didn't figure you did mean paint the insides but I cldn't figure out why exterior chipping would really interfere w the jets so figured I'd ask. Thanks guys...

You are talking about painting the exterior, right? Just clarifying, I'm a newb but was planning on engine painting this weekend. Would be good to know. Sent from my iPhone using DO THE TON

What a beaut. What year's your Honda? Sent from my iPhone using DO THE TON

Can u let is know if that worked? Because that just sounds awesome. Sent from my iPhone using DO THE TON