Search results

Hi guys, been awhile but I'm back with another rookie mistake and appeal to your collective knowledge on how to fix it. I've been slowly building up metallic paint on my CL360 rims to get a near-chrome finish. Things were going well, super shiny, until I went today to do final coat and bam...

Hi y'all. TL/DR: can I use JB weld to repair this hole in my tank? I was stripping paint from my Honda CL360 gas tank today and have been shakin stones and vinegar inside for about a week--suddenly just discovered this pinhole in the top of the tank near the seat due to rust (inside and out I...

hi guys. This'll be my first time rattle canning a tank. I plan to do a design in the same color and pattern like the one in the picture (not my tank, obv). When it comes to striping I usually see folks say lay the lightest color as base, mask with tape and spray new colors up to darkest. So...

Hi guys. Project is a 74 CL360 restore. The rear rubber tank mount is shot after the bike was sitting for 20+ yrs. i've seen a few on ebay but they seem kinda steep for something thats just rubber and isn't seen when the bike is put together. Question: does anyone have a hack recommendation...

I bought Rustoleum's very high heat primer (up to 2000F) to use on all of my '74 Honda CL360 but just realized it has to be baked three times, the last up to 600F. My main concern is the frame. I have a gas grill I can bake on for most parts but no idea what to do about the frame. Seen some...