Search results

Hello, I finally got my hands on my grandpas old ct90. Every few summers I would get it running while visiting my parents but now I have it in my garage and want to get it going full time. At the moment I am not getting any spark, I have tried new plugs, and cut off a bit of the spark plug...

Hey all. I had to take the rear wheel off of my gs750 to get a new tube last fall. Life happened and didn’t have a chance to put it back on until now. Going to re mount it I noticed a few extra spacers that don’t appear in the manual. Wondering if anyone could help me with the order they need to...

Posted this problem on Honda twin a while back but figured I would pick everyone's brain on here as well. My honda cb360 stopped running on the left cylinder. It has good spark and I checked the timing and it all looked good. I used a test light to check the wires going to the points and I only...

Hello all, So I had a flat on my cb and pulled the tire to replace the tube. I disconnected the rear brake arm from the drum instead of taking off the rear brake adjusting nut. When I went to put everything together the rear brake is fully engaged when I connect it to the wheel. First time...

So my bike is 76 cb360. The other day my bike died at a stop light on me. I noticed I wasn't getting spark on my left cylinder so I chalked it up to a dead plug and limped home. Once I replaced the plug and there is good spark on both sides but still not running on the left. It does sputter...

Hi all, I just took my carbs off to do a bench sync and realized the lock nut for the sync screw (in between the carbs) is missing. I haven't been able to find the size of it anywhere so I can get a replacement and wondering if anyone knows it. Thanks for the help! Sent from my iPhone using DO...

First off, I'm sorry for clogging the feed with questions, just keep having issues and you all a great help! My CB is leaking oil from what I think is the bottom left of the crankcase. (Could be completely wrong on that but attaching a picture of where). It's coming out pretty fast and has...

So I am trying to do valve clearance adjustments on my CB 360. I'm rotating the engine to line it up with the LT mark on the compression stroke but it spins on its own and I can't get it to line up unless I'm holding it in place. I did the cam chain adjustment recently and it worked fine. So...

So I have been rebuilding the carbs on my CB360. I was wondering if anyone knew of a place to get the float bowl gaskets for decently cheap? Also is there a way to make the old stretched out ones fit until I can order new ones? Sent from my iPhone using DO THE TON

Hello, So I want to put a much smaller rear fender on my cb360. I live in an apartment now so I am unable to shorten up my stock fender. I am wondering if there is any good and semi cheap aftermarket ones I can purchase? I've had no luck looking so far Sent from my iPhone using DO THE TON

Sorry in advance for the rookie question, but I was pulling the battery out of my cb360 today and a short clear tube that I hadn't noticed fell on the ground. It's not the battery breather and I can't seem to find anything about what it could be for. Thanks for any help, first time bike owner so...

I am relatively new to motorcycles, I picked up a cb360 last summer, I recently brought it in to the shop for a tune up since I am not very knowledgeable able. I noticed it idled higher when I got it back (between 2-3000 rpms). After riding for awhile when I am at stop lights and such it idles...