Search results

They came off my 350 with velocity stacks and a cl high mount custom exhaust...they still needed some tuning work but it did run.

I'm not against it, just don't know how much it would cost.

Well apparently my price is to high. I just followed what dine city sold them for. First person to PayPal 150 will get the carbs, intake boots, and included shipping.

They are no use to me and am willing to consider reasonable offers.

SOLD

Please pm me with price shipped…Thanks

Thanks guys, I actually bench synced the carbs wrong initially not fully understanding the procedures. All if fixed and Im riding now. What happened is none of the carbs were actually closing but staying open a 1/16 of an inch.

So I just got done rebuilding the 069a carbs on my cb550 and got everything back together. It has all been bench synced and have the vacuum sync gauges hooked up. I started the bike last night and it was fine carbs were running good and pulling the same vacuum. I kick started it today and the...

I guess my description was bad, the diagrams all show them as assemblies. I think they go on the shaft there the throttle cables go where the linkage spring is.

I didnt think so…I put everything back together without them for now and it all moves free…im going to just keep them in a baggy and hold on to them for the time being…

Im putting back together my linkage assembly for my carbs on my cb550F super sport and there are two teflon washers. I cant for the life of me figure out where they go looking at many pictures and diagrams. Any help would be greatly appreciated! Im assuming they are for the linkage assembly...

How do you determine if you need to move the clip on the needle? and what exactly does that do. I know it moves it higher or lower into the float bowl….so that lets it get more fuel if its lower in the bowl?

Hey guys, I very rarely post just troll in the backgrounds and soak up knowledge and pervious experiences from people. Im just about done renewing my fuel system on my 76 cb550f super sport. The gas tank liner started flaking apart and rust was clogging my lines, filter, so on. So i cleaned the...

that turned out beautiful

That thing is turning out to be pretty sweet looking! Keep it up!!

that thing is sweet!

hope mine ends that nice when its done!

This thing is so awesome! I was going to go the bratstyle route on my 350 project but came across a good deal on a bcr tank and seat so cafe it was…keep up the good work~

I think I am right in saying that the sl350 forks will work on my cb350 if i use the sl triples right? I just want someone to confirm before i buy a set. Please let me know thanks! btw I have a cb350k4 and am tring to put on sl350 front forks....

Like the title says Im looking for a cb360 front end, triples, forks, whatever…looking to clean up the front end of my cb350. Thanks, Ryan