Search results

I will add to this, being that this is my piston set up there in the pic... Cutting the crank counter weights, or adding metal for balancing, is typical in automotive machining.. From what I know of that, this difference in weight is a BIG No-No in engine balancing.. The question is then, do...

back from the grave. I had this issue, it took forever to dig up a solution, Ala this thread. I followed the "turn and press" (had to lightly tap, once I found a spot that wanted to let it in a bit) and got the cover on... A few miles later, the drive gear on the oil pump sheared...

Re: 1976 Honda CB360T - Purchase story and eventual build thread! You're tall. the 2-3" in drop with a thinner seat will benefit you. Do the geometry in your head. You would have all your weight on your arms..

Re: 1976 Honda CB360T - Purchase story and eventual build thread! ^^ Haters. ;)

Re: 1976 Honda CB360T - Purchase story and eventual build thread! Nice selection..

Interested when these hit..

Immediately, I could use the seat hinge pin. Like, mine was lost.. All thats holding it on is the lock. Interested in the seat pan too, depending. And what do the fork tubes look like? Jasontgipsonatjeemaildotcom email sent as well.. Thanks!

Jason Gipson Cincinnati, Oh Owner: Fuel Coffee Cincinnati 1975 CB360

What levers are on it? I need a clutch lever to match this old guy...

Umm. Email sent..

I need the finned set m'man. I'll call dibs.

Another side draft resurrection, sorry. But, is it decided that, due to crank design, a Weber DCOE or a Dellorto DHLA side draft carb is not practical, or impossible on a Honda motor? I have a set of DHLAs, and before selling them to a car buddy, I am researching to find out if I can use one...

Back from the dead here... but what became of the Dellorto and manifold? I am looking onto adapting a DHLA40 to a cb360 and would like to find out what, if anything was achieved!!

price?

As stated. A friend who isn't on the inter web asked me to try and track a set down. Thanks gents.

I really need a good set of carbs, I can part mine if I score a set.. I would hate to see working set get stripped!!! Assuming they are bolt on of course.. Email sent!

I have a set from a 72 350 twin. And as well, I need a usable set for a 75 cb360t. model 745B..