Search results

  1. N

    Let's see your Garage / Shop

    No sweat. Hit me up anytime.
  2. N

    Let's see your Garage / Shop

    About 30 miles north and east of Seattle - out in the sticks.
  3. N

    Let's see your Garage / Shop

    Near Monroe.
  4. N

    My cage has it's own cage

    look at the link http://www.pbase.com/donbe/the_deuce Don
  5. N

    Let's see your Garage / Shop

    I got the opportunity to build my dream workshop a few years back - so I did. My wife made one rule - it can't be bigger than the house. Guess what? I broke the rule. Here a shot of the machine shop area. I built the entire thing myself and outsourced just a few things - like sheetrock on the...
  6. N

    My cage has it's own cage

    Here are a bunch of shots from over the last few years. http://www.pbase.com/donbe/the_deuce Today it has a 340 CID Small Block Chevy with a powerglide and a Dana 60 with 5.13 gears. The motor has a dry sump, solid roller and shaft rockers. I'm planning on putting in Chevrolet's new LSX454R...
  7. N

    Age of the PNW cafe rider?

    You guys are punks 8) I am old ;D Don - 55 last June
  8. N

    My cage has it's own cage

    My '64 Chevy II run's 10.60s @ 129 Notice anything funny?
  9. N

    Tubing Bender

    The orange one shown in the first post is a pipe bender. Pipe is used for water and fluids and is all about the inside diameter. Tubing is different. You cannot expect nice, wrinkle free tubing bends from a pipe bender. Here is a cheap solution to build a decent bender on eBay...
  10. N

    How much is too much?

    This is my first post in this forum, but it seems like I'm right at home. In 1983 my wife bought me a new V45 Sabre for my birthday. It was the most awesome machine I've ridden and had a ton of technology - anti-rear wheel lock clutch, TRAC, BIG brakes, mono-shock with air and adjustable...
Back
Top Bottom