Search results

I have been having troubles with my CB high revving by itself and it has been suggested that I look at my Spark advancer to check old grease that may be causing it to stick. My question concerns the points, can they be removed to gain access to the advancer without disrupting their setting or...

Here's the deal after my bike is warmed up really well say 15 or 20 minutes or so and I come to a stop the bike climbs from 1 grand in rpms to 2 then 3 at idle. I know the float on my right hand side carb may not be set at the correct level since I replaced it a month ago after the original...

Let me start out by saying that my bike ran fine last year. Since then I have done the following: -Drained tank and float bowls last winter -Fixed, Derusted, painted tank -Cleaned petcock screen and replaced rubber piece in petcock -Added new fuel line with in line fuel filter for each line...

I have a few wiring questions regading the tailight and turn signals on my 72 CB350. The original tailight is being replaced with a new led unit that comes with three wires. Ground: black wire tailight: yellow wire brake light: red wire Which of these wires correspond to the original harness...

Hi, I feel like a real bonehead but I took apart my left control so I could clean it up and repaint a couple weeks ago and now that I am ready to reassemble my pictures that I took are kind of fuzzy and not a lot of help to me. Could someone take some clear shots of the top and bottom of the...

Well I figured it is about time to start a post on my 350 since I will be slowly working on her this winter and spring. It is a 1972 cb350 with about 5500 miles on it that I purchased late last summer. The first picture is when I bought it The second picture is a temporary seat cover I made...

Thought I would share some pics of the seat I built for my CB. Still have a little shaping work to do in the nose area but it is about 95 percent shaped. I just wanted to keep my stock pan and still make a functional cafe seat. It will be a while before I get to wrap it, but I will post when...

http://www.motorcyclenews.com/MCN/News/newsresults/New-bikes/2009/September/sep3009-2010-honda-cb1100-revealed/

I have a 72 CB350 and so far this summer I have replaced the tailight bulb 5 times, the last one lasted 3 days. It's usually the taillight element that burns out not the brake light element. I am pretty sure that I am using the right bulb I can't remember the number off the top of my head but...

I had some scrap vinyl laying around from previous projects so I decided it was time to recover my seat since there was a large slit in the side and I finally got the bike to the point of being safe and reliable, knock on wood. So I stripped the old cover did some foam work, made a cover and ta...

right now the tire rubs, any suggestions?

Hi, I just got my tires and tubes installed today with the help of a friend, the problem is now I have a misfire issue, and I am not quite sure where the issue is coming from. The following is what I know: -New NGK Plugs set to proper gap -Point cleaned and gapped properly according to the...

I will attempting the install of wheel bearings on my CB350K4 this weekend, I have read on here that you can use a socket to tap the bearing back into place as long as you tap on the outer race. I know it sounds dumb, but how do you use the socket to tap the bearing? Do you attach an extension...

Just bought a CB350, mostly looking to make it safe and reliable, cool comes second especially with a little one at home. With the help of a friend I will beinstalling new wheel bearings, rim strips, tubes, and tires this weekend. As for future plans I plan on modifying the stock seat into a...