Search results

For Sale or Part Out: This was a project near completion that I just ran out of time, and room for and now want to take the $ elsewhere, the only things the bike needs are some carb. work and a muffler. I have the clean title in hand. Engine rebuilt less than 100 miles ago. New parts: Custom...

I have been around the forum for awhile and have nagged quite a few members...here is where my project is currently. Before: After: Existing issues: (any advice on either is GREATLY APPRECIATED) -left side power is intermittent -loss of power on hills(surely due to the first...

So, doing a little testing and realize the left coil is shot, time to step into both I suppose. Would love to get my hands on some NOS coils if possible as i love the plug and play/plug and mount aspect. Any help, advice is appreciated. Open to trades for items I have for sale.

I did a bit of searching around the site and came up with a few answers close to what i was looking for but none exact. So, my question is, when eliminating the kill switch (76' cb360), do you then have to jump the kill switch' wiring as well (to put in constant run position) ? Thanks from a newb.

I have to 2 1/2 ft spike strips for sale. These are used by riveting the spike strips to the bottom of a seat pan, you then wrap your seat covering of choice over them and then fold down the spikes on the spike strips to hold the seat covering in place. I used a similar set for a custom seat...

I have to 2 1/2 ft spike strips for sale. These are used by riveting the spike strips to the bottom of a seat pan, you then wrap your seat covering of choice over them and then fold down the spikes on the spike strips to hold the seat covering in place. I used a similar set for a custom seat...

Hello all, _____________________________________________________________________________ Clarification: Levers are one of my current dilemmas, as I want to get away from any handlebar electronics. I would like to find a set that might possibly work with the stock clutch cable, and mount up with...

Tear down on a bike, just to rebuild..and here are some parts I will not be needing. If interested please PM your offer (including shipping and paypal fees). Thank you.

I have admired this bar set-up and tried to find the owner directly but have been unable to. Can someone help? Below are a couple of the owners pictures and the inverted risers, any help contacting the owner or someone that knows how to get the clubmans behind the forks is appreciated...

The journey begins.... I am sure I will have plenty of questions, The first being, What percentage of you actually have reliable running cb's? Thanks alot!