Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature currently requires accessing the site using the built-in Safari browser.
We noticed you are blocking ads. DO THE TON only works with community supporters. Most are active members of the site with small businesses. Please consider disabling your ad blocking tool and checking out the businesses that help keep our site up and free.
Hey all,
I have some of those. Top. Quality. Rfy shocks . Anyhow can anyone tell me if they have rebuilt them, where they got seals from to match? I am unable to find any that are the same
Hi all
just wondering what sprocket combinations everyone is running??
on my cl350 im running a 17 tooth front and the standard rear and sits around 6200rpm at 100km/h.
i was wondering if it would be suitable to drop the gearing again so it revs a little lower because i do quite a bit of...
I have been reading through the workshop manual and all seems correct.. i thought it was running too lean at first so i shimmed the needle for the main jet so it would run richer but its still having the same issues so now i dont know what the next step is after timing.. have trid with and...
Hi guys. I'm having another issue with my cb350!, i sorted out the high rpm miss when i found that one resistor cap was not contacting the ht lead properly, however now i have an issue under light throttle when i set off from idle where it seems to be quite rough unless i fully open the...
Cool. Will try model store tomorrow for some small enough o rings.. Petcoxk shoukd be fine as i had to diy make a new rubber seal so now the fuel wont stol flowing even in rhe 'stop ' position haha.. And float biwls were overflowing until i sorted that problem earlier today.. So i definately t...
Hey guys this is my first post on here ..
Just got given a 72 cb350 and have got her all running except whenever the revs reach around 6000 rpm like highway driving it bogs down.. I have cleaned the carbs and replaced o rings and gaskets except the o rings on the 2 removable jets in the float...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.