Search results

So here's the deal. 73 CB750 New wiring harness New battery New rm stator solid state rectifier/regulator i checked the stator and have resistance in spec between all three yellow. @.9 to 1.1 ohms nothing to gnd. I even soldered the connections, no change the field coil resistance is a...

In need of some help here. Has anyone experienced oil coming out of the pipe? Not a little, a lot. CB750, rebuilt bottom end, top was ok. Oil level is where it should be Help. JJ

Gentlemen, Save for a couple of vintage decals, some polishing, and tuning my CB836 is complete. Rolled it out of the house today and snapped a few. Enjoy. First a pic of it halfway stripped. My comp crashed with the other before pics. then,

I was outside setting up the bike after getting it running and i noticed something out of the norm. I was measuring the temperature of my exhaust pipes at the same spot on each, around six inches from the head, and came up with some numbers. Cylinder 1 past 300 deg F Cylinder 2 past 300 deg F...

The motor is a new 836, never been fired. I cranked it over for about two minutes with no build in pressure. I have a gauge at the port just above the points cap and an oil light which didn't go out either. I won't fire it until i have pressure. Just wondering how long it should take to...

Putting the bike back together i have all the electrical working except for the headlight circuit. The harness is new and everything else works. Consulting the wiring diagram for K1-K5 Cb750 it looks like power for the headlight circuit happens at a connection point from the tach light circuit...

For anyone interested, http://www.sea-dog.com/cgi-bin/webdata_pro.pl?_cgifunction=search&_layout=pdfs&pdfs.itemgroup=Vents%20%26%20Fuel%20Fittings Some excellent options for gas tank fillers. I have the monza style, top notch product.

So i know there are a few left coasters here; How many representing Vancouver and surrounding areas...? Me - Coquitlam

So I have gone and added another disc up front on my cb750. When fitting all of this clearance and spacing were major issues just to get the units assembled. Calipers are all rebuilt and pads are new. Fluid has not flowed through this system yet. Rotor thickness is equal from side to side...

Hey guys, Thought i would drop in after lurking for awhile. Looks like spring is just around the corner here, so i had better pick up the pace on this build. Started as a crusty 73 CB 750 cruiser and is nearly a full blown rocker. Now if i could figure out posting pics..... Do i have to...