Search results

  1. sneakypete

    quick question on table syncing carbs

    Hey guys, I got a quick question in regards to table syncing carbs.. When using the 1/8 drill bit technique, which side do you gap from...engine or intake? Also, how far down should the idle screw be when doing this?
  2. sneakypete

    Rear Shocks...rebuild

    Hey guys, I have a two pairs of factory shocks from a Honda CB550 that are blown out. I've been having trouble finding info on how to rebuild them or if it's even possible to rebuild these factory shocks. Any help would be greatly appreciated....Thanks
  3. sneakypete

    So here it is.....my new hobby.

    .......I was avoiding getting into to this like the plague.....i finally gave in. ....I am now a proud / frustrated owner of a 1974 Cb 550.
  4. sneakypete

    1974 CB550 carb O rings

    Does anyone know where i can get some O rings for a carb rebuild on a 1974 Cb550 4...or the size of the O rings? I could really use some help..thanks
Back
Top Bottom