Search results

You guys are so incredibly helpful. Thank you

I've been trying to research CB450 exhaust/muffler options and I'm kind of coming up short on finding the information that I need. Would these mufflers work on stock CB450 headers, and perform normal or better than stock...

Yes they are currently chrome. I painted my forks, and just hit them with some sandpaper and then wiped it as clean as I could, and it stuck and looks really clean and smooth. Would it be safe to assume if that went so well, the same paint and sand paper treatment would give the same result...

That is genius scruffy thank you!

What specifically are you trying to clean? That way I can find a cleaner that is in between simple green and airplane stripper.

Thank you sir, that's really reassuring. My room mates keep telling me they're certain it will cause problems, but i'm certain they're just stupid.

So I replaced the bearings, sanded and cleaned, and then trued the wheel with a buddy of mine. If i tape off the innards enough- would it mess anything up to just rattle can the spokes and rim? So far my only concern would be it not looking as smooth as a powder coat finished rim- but at the...

That seat is amazing. Post updates when you round out the tank a little bit! I'm sure it's going to look mean.

So all it ended up taking was a knife and a hammer. I just started to hammer from the inside threads, which seemed relatively fine(as stated above) and hammered outwards. It took some time, and some chunks certainly came off, but it went in. Moving forward yay!! You guys rock

I totally did not drill those out, so I own that it's my own mistake. I will go buy a nice small file and attempt to clean that entry point up. I really appreciate the response! If I can't seem to get it to lock in to start the threading, do i have any other options? It looks like the best...

So this is the first thing i've had to make a post for, since any question i've ever had has been answered for my project. I was replacing the front wheel bearings, and ended up buying the tool to remove the bearing retainer lock (since nothing else worked, i finally found one). When I got the...

New to the site: Good first post to read, and very simple to follow. Thanks for the advice.