Search results

I have an opportunity to pick up a 1978 CB 750 K frame with title and also an 81 CB 750 solid running engine, my question is will it fit without modification or even heavy modification? Sent from my iPhone using Tapatalk

I have a CB350 that will start once I spray starting fluid in the carbs. I did just rebuild one of the carbs and was trying to test it out and now the bike will not stay running after fluid has been used up. Sent from my iPhone using Tapatalk

Hey all, Well I have the bug, I finished my cb350 build and now I am already on another. I have a leak on a bike that I have, it is a 1976 xl250. It is leaking from the left crankcase and the stator cover. On the case itself, the receiving hole is stripped. So I have been looking everywhere...

Hey All, I just swapped out my motor on a project bike so that I can rebuild the original motor. I used a SL350 motor which is slightly different. I have made all of the appropriate alterations for the brake pedal, kickstart ect. The one issue I am having is haveing the clutch engage. I...

I am trying to find out how to set the timing on a 76 XL250. What Top Dead Center is and are there any secrets I may need to know. This bike has a push/pull style throttle. The push cable broke and before this it would start and run. Now the bike wont start. I have spark, the carbs have...

I adjusted the clutch cable to the appropriate level of resistance. It shifts into 1st and back to neutral a little to easily. But when i try to shift into 2nd it wont go. It was working ok before the cable adjustment, a little sensitive but it was shifting. Was hoping for a little hope...

I would like to buy the clutch retainer ball or the entire Clutch Actuator for a 72 CB350. Thanks! (http://www.cmsnl.com/honda-cb350k4-england_model16400/retainer-ball_22860286000/#.Uh1plD9cWf4)

I have a 1972 CB350 and I was changing out to a new clutch cable. When i had everthing done, thinking I did it right, I put the cover back on, tried to engage the clutch and nothing very little tension. I tried to tighten it up with the clutch adjustments, but it just got tighter and the clutch...

I want to test run the cb350 I have been working on. I was just looking to eliminate everything except what will make the bike run, anyone have a diagram for this or simple instructions?

Hey all I am about to start wiring my bike up and I am converting to LED taillights and turn signals. I was hoping someone would have a simple conversion for this as well as a new cheap regulator/rectifier that I could find to use for a Lithium battery. Any help would be appreciated, I hate wiring!

I wanted to put a new front end on my 1st motorcycle build. I have a 71 cb350 and I have an opportunity to buy a late 90's ninja 250 entire front end as well as rear tire and swing arm. I know I cant use the swing arm because it is a monoshock. I am more curious of if the front triple tree...

I was going to buy the Dynatek Coil "Mini Series," Single Lead #DC3-2 for a 1971 CB350. I was curious what else I need. The bike is curently stock right now and I was hoping I didnt need anything else besides this and spark plugs and wires. Any help would be great! Thanks, DS

So simple question, how do I remove the plate in the lower crankcase?