Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature currently requires accessing the site using the built-in Safari browser.
We noticed you are blocking ads. DO THE TON only works with community supporters. Most are active members of the site with small businesses. Please consider disabling your ad blocking tool and checking out the businesses that help keep our site up and free.
Hi stan0matic, I adjusted the tappets as per your instruction and gave the bike a run, all seems ok. There is a tappet noise that was not there from new but as there was no gap when I originally checked then that is not a problem.
Wayne
The nuts were tight when I rechecked them. I gave the bike a short ride last night and it appeared to be ok although it may have been slightly down on power.
Wayne
I decided to finally change my rear sprocket at the weekend, my only problem was trying to raise the back wheel off of the floor. After many attempts with the wife using blocks of wood I had a flash of inspiration and used the ladder and a couple of ratchet straps.
Wayne
Thanks Stan,
I will take any advice that gets me back on track. I did reset everything yesterday afternoon and the bike started ok, but I did not go for a ride as I wanted to get advice from the guys on here.
What confused me was that for the first 15km everything was fine and then the...
Help! I have adjusted my valve clearance to .002". I also replaced the rear sprocket from 38 teeth to 35 teeth. I took the bike for a run and all seemed well for the first 15km. The bike then lost power like it had run out of fuel but picked up again after about 5 seconds. It did not sound right...
Thanks Tad. Would you recommend just replacing the standard foam over fitting a replacement filter assembly. I was not looking to replace the carb at this stage. I have re-jetted with 45/95 and fitted the derestricted chrome Skyteam exhaust. I am maxing out at 65mph as was looking to try and...
I am looking to replace my air filter with one from OORacing:-
http://www.ooracing.com/store/index.php?act=viewProd&productId=3719
What modifications do I need to make so that this will fit? Can I keep the original battery in the same place?
Thanks
Wayne
At the bottom of this ebay advert it has a list of wire colours.
Wayne
http://www.ebay.co.uk/itm/291007338937?ssPageName=STRK:MEWAX:IT&_trksid=p3984.m1423.l2649#ht_3501wt_958
Thanks for all your replies. I have disconnected the side stand switch so it could be that the plug just ended up on top of the frame when I removed the carb. the neutral light is still working (although neutral is still a pain to get sometimes).
Wayne
I had the tank off at the weekend and found a multiplug with a green/white wire that was not connected to anything. Does anybody know what this is for?
Wayne
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.