Search results

Ok, I have a strange issue that has me scratching my head. I am close to taking my 72 CL350 on a break in ride, however I'm having an issue where when the key is shut off, the engine remins running on one cylinder. I don't use the kill switch, I have bypassed it and run the black (hot when key...

Hello, So I know there are 50 different ways of breaking in a motor after rebuild, and I need some opinions for a 72 CL350. My project is pretty much done (for this year) and it involved going through the top end of the motor, with replacing cam chain and tensioner wheels/guides, rings, and...

Hello, I have a 1972 Honda CL350 that I am working on. My problem is when I was assembly the components in the right crankcase cover, I managed to break one of the teeth off the clutch basket. When I say teeth I am referring to the tabs on the outer edge of the basket. My question is, would...

So I found this little project on the good ole' List of Craig and it may be a possible project since I want a second project (I didn't say NEED) and have a boat, and they have a bike and want a boat. http://bn.craigslist.org/mpo/4333202582.html My current project is a 72 Honda CL350, which is...

Due to the budget of my build quickly fading, I am choosing to paint my frame and swingarm. I plan to use the Rustoleum Appliance Epoxy, however I wasn't sure on if primer is needed with this stuff. The swingarm has been sanded down to bare metal, and the frame is currently at the shop for...

I am currently working on the top end of a 72 Honda CL350 and am having an issue with removing the pistons. I have removed the circlip from the ends of the pin, however the pin will not slide out. Should there be any resistance on these during removal, or should they just slide out? I have...

I am currently working on a 1972 Honda CL350 K4, and while in the motor I had a few questions. My cam chain tension is completely shot (center wheel) and the front guide is worn and will be replaced as well. One question I had, is how can you tell if a cam chain is in need of replacing? It...