PBRStreetgang
New Member
Hello,
I'd like to do a dynamic carb sync on my CB200T with a manometer similar to this one :
http://www.youtube.com/watch?v=w6ZqzJgbhyw&feature=endscreen
I have the vacuum taps on my manifolds :
But what do folks use to connect to the taps? I was thinking drilling a hole through a bolt would be the ticket, but I wanted to check with folks to see if there was an easier way.
Any input would be appreciated.
Thanks,
MJA
I'd like to do a dynamic carb sync on my CB200T with a manometer similar to this one :
http://www.youtube.com/watch?v=w6ZqzJgbhyw&feature=endscreen
I have the vacuum taps on my manifolds :
But what do folks use to connect to the taps? I was thinking drilling a hole through a bolt would be the ticket, but I wanted to check with folks to see if there was an easier way.
Any input would be appreciated.
Thanks,
MJA