74 CB750 USD and Mono build
- Thread starter chowpay
- Start date
50gary said:
Hi Gary its just about 2:1 But its an increase leverage so past 1 the rate increases for example to 2.2 etc until the full rang of the shock is used. I had to do it this way because CBR600F3 has a rocker arm that increases the link ratio through out the travel so the rate increases as the swing arm goes up into the fender.
Hey Guys
Sorry for the lack of updates. A friend of mine is loading up a project and I had to create a tube notcher
in order to start on the project.
BUT since it is semi-bike related I'll post it here.
I took the CBR linkage that was unused from this bike build:
And turned it to a JMR tube notcher clone. Here's the carriage :
After a lot of machining these scraps:
became a tube notcher (minus a bolt and bar that allows it to be clamped onto a vice)
If you're curious heres the full build gallery: http://imgur.com/a/PEQOY
With this almost out of the way I hope to get back on working on the bike
Sorry for the lack of updates. A friend of mine is loading up a project and I had to create a tube notcher
in order to start on the project.
BUT since it is semi-bike related I'll post it here.
I took the CBR linkage that was unused from this bike build:
And turned it to a JMR tube notcher clone. Here's the carriage :
After a lot of machining these scraps:
became a tube notcher (minus a bolt and bar that allows it to be clamped onto a vice)
If you're curious heres the full build gallery: http://imgur.com/a/PEQOY
With this almost out of the way I hope to get back on working on the bike
