'81 GL1100 'On The Road Again' (hopefully)

[boingk]

Pick at the blockage gently with a pin, then thin wire (from a wire brush perhaps, or fuse wire/paperclips). If its a decent opening thread wool or cotton yarn through and run it up and down.

Failing that, use a pipecleaner...the fuzzy things you bent around into shapes and structures as a kid. They make a good tie down for loose bits, as well as a jet polisher and general useful thingy. Yeah...technical.

Good to hear its coming along - boingk

 

[JRK5892]

i have also used ultra fine drill bits, dental tools, pipe cleaners, but boil in lemon juice really does the trick!

 

[Skyeye]

Be very careful, the jets are brass and soft. Make sure that you don't do anything that will change the size of the hole. If you can get a small hole started, then lemon juice will work even faster.

Scott

 

[xci.ed6]

Tested the H/l

That looked too high, so I lowered it.

Then the gauges looked too high, so I flipped the bracket.

It is big, I'm 6'1, anyone smaller would probably feel stretched out.

 

[JRK5892]

nice man! have you looked into a altinator conversion at all? there is alot of cool things we can do with these suckers!

 

[xci.ed6]

Been busy, so no updates, but I do have pictures of the progress I've been making. Just wanted to throw this one up quick and see what everyone thought.

 

[JRK5892]

I love it!!